Omron V530-R150E-3 -, Operation Manual

Page: 243 / 300

226
Maintaining and Replacing Light Sources
Section 7-1
7-1-2 F150-SLC20/SLC50 Maintenance
Removing the Light Source
1,2,3...
1. Disconnect the light source cable from the light source connector
on the back of the Camera.
2. Remove the light source cable from the slot in the camera base.
3. Remove the top two screws securing the light source.
4. Remove the bottom two screws securing the light source.
5. Remove the light source from the Camera.
!Caution
Do not disassemble the Lens.
Note When the Camera is being used without the Intelligent Light
Source, the top screws shown in step 3 are not needed and the
bottom two screws shown in step 4 will be too long and won’t fit
the Camera. Use two M2
™
3 screws for the bottom screws
instead.
Part Field of vision Model number
Light
Source 20 mm F150-LTC20
50 mm F150-LTC50
Camera base
Light Source
Hold this section when
removing the cable.