Omron V530-R150E-3 -, Operation Manual

Page: 241 / 300

224
Maintaining and Replacing Light Sources
Section 7-1
7-1 Maintaining and Replacing Light Sources
• The Light Source will gradually become dimmer as it is used
(approx. 20% dimmer after 1,500 hours of operation). Replace
the Light Source after approx. 1,500 hours of use.
• Replace the Light Source if it is partially damaged or not fully
functioning.
7-1-1 F150-SL20A/SL50A Maintenance
Note The F150-LT10A Light Source cannot be connected to the older
F150-S1 Cameras.
Removing the Light Source
1,2,3...
1. Disconnect the light source cable from the light source connector
on the back of the Camera.
2. Remove the light source cable from the slot in the camera base.
3. Remove the two screws securing the Light Source.
4. Remove the Light Source from the Camera.
!Caution
Do not disassemble the Lens.
Part Model number
Light Source F150-LT10A (See note.)
Camera base
Light Source
Light source
connector
Camera cable
connector
Hold this section when
removing the Cable.