Omron V530-R150E-3 -, Operation Manual

Page: 155 / 300

138
SET (Setting) Mode
Section 6-1
6. Press the TRIG Key on the Console to perform one reading.
Note Parameters will be set based on the results of this reading. If the
reading is performed correctly, the teaching function will automat-
ically turn OFF. To redo the settings, go to SET mode and repeat
the procedure from step 1.
It is possible to view and, if necessary, change the parameter set-
ting in Reading Settings (Manual).
“
page 139
If reading is not performed correctly (NG), the teaching func-
tion will stay ON. To turn the teaching function OFF, select
Reading Settings (Manual) from the screen shown in step
2, and press the ENT Key. The teaching function will be
turned OFF by entering the Reading Settings (Manual) win-
dow.
Note If the teaching operation is not successful, measure the length of
finder pattern using Image Analysis/Measure Length and set
this value for length of the finder pattern in Reading Settings
(Manual), and then repeat the teaching operation.
The parameters obtained are displayed.
These parameters are registered as settings.
In RUN mode, only the read data (1234567890
in this example) is output to RS-232C.