4-13
D
Operation Procedure
PR02W
Front panel
key operation
Display example
Explanation
Press the MODE SET Key to change to System Check
Mode.
Select function code Fn002 using the Up or Down Key. The
digits you can operate will flash.
(1 s min.)
Press the DATA Key (front panel: DATA Key for 1 s min.).
The jog operation will be enabled.
Turn ON the Servomotor.
Press the Up Key. While the Up Key is held down, the Ser-
vomotor will rotate forwards at 500 r/min.
Press the Down Key. While the Down Key is held down, the
Servomotor will rotate in reverse at 500 r/min.
Turn OFF the Servomotor.
(1 s min.)
Press the DATA Key (front panel: DATA Key for 1 s min.)
to end the jog operation and return to the function code dis-
play.
Note 1.
You can end the jog operation with the Servomotor turned OFF. When the display returns to
Fn002, the Servomotor will turn OFF automatically.
Note 2.
The 2-digit LED bit display before the “JoG” display is the same as the bit display in Status
Display Mode.
D
Changing the Rotation Speed
•
The default setting for user parameter number Pn304 (jog speed) is 00500 (500 r/min.). You can
change this setting to change the rotation speed during a jog operation.
•
Try changing the jog speed setting to 01000 (1000 r/min.)
Setting Mode jog
speed
Pn304 setting displayed.
Change setting.
Data memory (See note.)
Finished writing data. (Display flashes).
After approx. 1 s
1 s min.
1 s min.
1 s min.
Note
When changing the setting, first press the DATA Key (front panel: DATA Key for 1 s min.) to write
the data to memory, then press the Key again to return to the parameter number display. You can-
not return to the parameter number display without saving the changed data to memory.
Operation
Chapter 4
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]