4-16
4-4
User Parameters
Set and check the user parameters using the Setting Mode. Make sure you fully under-
stand the parameter meanings and how to set them before setting user parameters in
the system. Some parameters are enabled by turning OFF the Unit, then turning it ON
again. When changing these parameters, turn OFF the power (check that the power
lamp is not lit), then turn ON the power again.
4-4-1 Setting and Checking Parameters
H
Operation Overview
•
Use the following procedure to set and check parameters.
S
Go into Setting Mode:
(
)
S
Set the parameter number (Pn
jjj
):
,
,
(
less than 1 s),
S
Display the parameter setting:
(
for 1 s min.)
S
Change the setting:
,
,
(
less than 1 s),
(Not required for checking only.)
S
Save the changed setting to memory:
(
for 1 s min.) (Not required for checking only.)
S
Return to parameter number display:
(
for 1 s min.)
H
Operation Procedure
D
Going into Setting Mode
PR02W
operation
Front panel
key operation
Display example
Explanation
(Status Display Mode)
Press the MODE/SET Key to go into Setting Mode
D
Setting the Parameter Number
PR02W
operation
Front panel
key operation
Display example
Explanation
(less than
1 s)
Set the parameter number you want to set or check. If
the parameter number is too big, you can set the
operation to be performed more quickly while changing
the operation digits, using the Left Key (front panel:
DATA Key for less than 1 s) or Right Key.
•
Unused parameter numbers are basically not displayed. For example, if you press the Up Key on op-
eration digit No. 0 while displaying parameter number Pn005, the display will change to Pn100 (as
Operation
Chapter 4
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]