4-6
PR02W
operation
Front panel
key operation
Display example
Explanation
(Baseblock display)
Press the MODE/SET Key to change to System Check
Mode.
Press the MODE/SET Key once again to change to
Setting Mode.
Press the MODE/SET Key once again to change to
Monitor Mode.
(Press and hold
for 1 s min.)
Press the DATA Key to display the Servomotor speed
(r/min). Un000 is the speed feedback monitor number.
(See note 1.)
Rotate the Servomotor shaft
forwards by hand.
Rotate the Servomotor shaft forward to check that the
speed is displayed. (Refer to the diagram below.)
Rotate the Servomotor shaft
in reverse by hand.
Rotate the Servomotor shaft in reverse to check that the
speed is displayed. (Refer to the diagram below.)
Note 1.
If using the operation keys on the front panel, press and hold the DATA Key for one second or
longer.
Note 2.
Refer to
4-3-1 Operation Details
for details of operations.
Reverse rotation
Forward rotation
Seen from the Servomotor output shaft, counterclockwise
(CCW) is forward rotation, and clockwise (CW) is reverse rota-
tion.
Forward/reverse Servomotor rotation
If the direction of Servomotor rotation and the speed feedback monitor symbols do not agree, the
Encoder Cable may be incorrectly wired. Check the conduction for each cable.
•
If there is an error, refer to
Chapter 5 Troubleshooting
and take the necessary countermeasures.
4-2-2 Absolute Encoder Setup and Battery Changes
You must set up the absolute encoder if using a Servomotor with an absolute encoder.
Perform the setup if connecting a Battery Unit (R88A-BAT01W or R88A-BAT02W) to an
absolute encoder for the first time, or when setting the mechanical rotation data to 0 for a
trial operation.
H
Absolute Encoder Setup Procedure
•
Be sure to follow this procedure carefully. Any mistakes in carrying out this procedure could result in
faulty operation.
Operation
Chapter 4
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]
