F-30 PREPARATION BEFORE STARTING MASS PRODUCTION
d)
Press the
[(+) INPUT]
soft-key.
1.
If the
(INPUT) key is pressed, the
value having been input with data entry keys
is input for the tool wear offset data.
Therefore, make sure to press the
[(+)
INPUT]
soft-key.
2.
Make sure that the decimal point and the
plus or minus sign are input correctly.
24)
Select the memory mode (
) with the MODE
selection switch.
25)
Display the PROGRAM (memory) screen.
26)
Press the
[TOP]
soft-key
27)
Make sure that the cursor is at the head of the
program.
28)
Close the front door.
29)
Press the
(ST) switch to finish the workpiece.
30)
After finishing the workpiece, measure the
workpiece dimensions again and input the tool wear
offset data.
31)
Start automatic continuous operation after obtaining
the tool wear offset data precisely for all the tools.
Before starting automatic operation:
a.
Invalidate the single block function
b.
Invalidate the optional stop function
c.
Invalidate the coolant off mode
After starting the automatic operation, check the
dimensions of several finished workpieces. The
dimensions will vary slightly due to initial tool
wear, cutting resistance, deflection of cutting tools,
and other factors.
NOTE
INPUT
MODE
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
CYCLE
ST
SP
NOTE
