SETTING OF COORDINATE SYSTEM E-11
17)
Press the
(STOP) switch to stop the spindle.
Repeat steps 13) to 17) until the end face, I.D. and
O.D. of the workpiece are cut.
18)
With the manual door type machine, press the
DOOR UNLOCK switch
to unlock the front
door. Then open the front door.
With the automatic door type machine, open the
front door by pressing the AUTOMATIC DOOR
OPEN switch.
19)
Measure and record the O.D. and I.D. of the
workpiece.
<Example>
Measured value................O.D. 50.0 mm
Measured value................I.D.
30.0 mm
For the procedure used for setting the
coordinate system by the tool using the tool
geometry offset function, refer to page E-12
NOR
SPJ
STOP
REV
NOTE
DOOR UNLOCK
NOTE
