F-22 PREPARATION BEFORE STARTING MASS PRODUCTION
20)
With the manual door type machine, press the
DOOR UNLOCK switch
to unlock the front
door. Then open the front door.
With the automatic door type machine, open the
front door by pressing the AUTOMATIC DOOR
OPEN switch.
21)
Operate the chuck to clamp a workpiece.
22)
Close the front door.
Make sure that you can press the EMERGENCY
STOP button or the
(SP) switch immediately
if an abnormality occurs.
23)
Check the tool motion on the PROGRAM screen by
pressing the
(ST) and
(SP) switches
alternately. Check the interference between the tool
and the workpiece or the chuck.
1.
The program stops at each block as the
single block function is valid.
However, press the
(SP) switch if the X-
or Z-axis starts moving.
2.
If the coolant OFF mode is currently valid,
coolant will not be supplied even if an M08
(coolant ON) command in the program is
carried out.
24)
Check the clearance between the cutting tool and
the chuck in comparison with the data for "DIST. TO
GO" which is displayed on the screen.
The cutting tool to chuck clearance should be
checked through the window in the front door.
If the cutting tool would strike the chuck if the
program were executed continuously, stop dry run
operation and correct the program. Then, check
the program again.
DOOR UNLOCK
NOTE
NOTE
CYCLE
ST
SP
NOTE
NOTE
