F-28 PREPARATION BEFORE STARTING MASS PRODUCTION
16)
Set the rapid traverse rate override, feedrate
override, and spindle speed override if necessary.
Make sure that you can press the EMERGENCY
STOP button or the
(SP) switch immediately
if an abnormality occurs.
17)
Press the
(ST) switch.
Proceed machining by observing vibration of the
machine, cutting sound, chip discharge condition,
and coolant supply condition.
18)
With the manual door type machine, when the
program stops after executing the M01 (optional
stop) command, press the DOOR UNLOCK switch
to unlock the front door. Then open the front
door.
1.
With the automatic door type machine, when
the program stops after executing the M01
(optional stop) command, open the front
door by pressing the AUTOMATIC DOOR
OPEN switch.
2.
Before opening the front door, change the
operation mode to manual with the MODE
selection switch.
3.
The machine does not stop if an M01
command is not entered at the end of the
program. Programs used for continuous
operation may not have the M01 command
to shorten cycle time.
19)
Measure and record the dimension of the
workpiece.
20)
Repeat steps 17) to 19) until program end command
M30 to measure and record the dimensions.
NOTE
SP
CYCLE
ST
SP
NOTE
DOOR UNLOCK
NOTE
