B-52 MANUAL OPERATION
12-3
Tailstock Spindle Interlock
By setting the tailstock spindle interlock function (TAILSTOCK ILK.) ON, cycle start is disabled if
the tailstock spindle is retracted into the tailstock body. Starting the memory (tape) operation (for
center-work) while a workpiece is not supported by the center (tailstock spindle) will cause
hazards such as the workpiece flying out. This interlock function ensures safe operation by
preventing such hazards.
1)
Display the OPERATION PANEL screen.
2)
Move the cursor to "TAILSTOCK ILK." using the
cursor control key
or
.
3)
Set the tailstock interlock function ON/OFF using
the cursor control key
or
.
<For interlock ON>
Press the cursor control key
.
<For interlock OFF>
Press the cursor control key
.
4)
Press the
[EXIT]
soft-key.
WARNING
Always switch the tailstock spindle interlock function ON before carrying
out center-work operations. If this function is OFF, it will be possible to
start the memory (tape) operation when the tailstock spindle is extended,
even though it may not support the workpiece correctly. If memory (tape)
operation is started in this condition, the workpiece will fly out, causing
serious injuries or damage to the machine.
EXIT
1
F
10
F
2
F
3
F
4
F
5
F
6
F
7
F
8
F
9
F
