SETTING OF COORDINATE SYSTEM E-47
<Z-axis direction>
A
Drills, reamers
Rotary tools
Open the front door and measure
the tool diameter with a
micrometer or vernier calipers
Close the front door
Move the tool near the stylus
After making sure that the machine is stopped, open the front door
The tool geometry offset data is input to the GEOMETRY OFFSET screen*
Check the gap and positional
relationship between the stylus
and the tool
Check the gap and positional
relationship between the stylus
and the tool tip
Close the front door
Move the tool near the stylus using the manual pulse generator
Move the tool tip to the same level
as the stylus face
*3
Open the front door
Press the stylus by your finger
*4, *5
Close the front door
D
<X-axis direction>
Yes
No
No
Yes
B
C
No
Yes
Thread cutting tools, straight tools
Input the distance from the spindle
center line to the X-axis zero point
for the I.D. tool holder or rotary tool
to "X" on the GEOMETRY
OFFSET screen ***
Tool mounting
direction
Type of tool
Is it possible
to visually check the gap
and positional relationship between
the stylus and
the tool tip?
Is it possible
to visually check the gap
and positional relationship
between the stylus and
the tool?
Do you use the
presetter measurement
sub mode?
Input the diameter of the rotary tool
with the negative value to "Z" on
the GEOMETRY OFFSET
screen**
Bring the largest diameter area of
the rotary tool into contact with the
stylus
*3, *4
