C-16 CHUCKING
23)
Set the chuck clamping direction to the O.D.
chucking.
For chuck 2, page 2 of the OPERATION PANEL
screen is used to the selection of clamp direction.
24)
Set "INVALID" for CHUCK STROKE END (chuck
jaw stroke end detection function) using the cursor
control keys.
For the selection of valid/invalid of chuck 2
confirmation switch, page 2 of the OPERATION
PANEL screen is used.
The STATUS indicator
[CHCL]
is lit.
For chuck 2, the status indicator
[HEADSTOCK 2
CHUCK CLAMP]
on the option panel is lit.
25)
Check for interference by following steps 13) to 15).
26)
After making sure that the spindle can be rotated
without interference, close the front door.
27)
Start the spindle manually.
28)
Set the required spindle speed.
Determine the spindle speed by considering the
soft jaw height, diameter to be cut, and the tool
material.
29)
Feed the cutting tool on the Z-axis with the manual
pulse generator to bring it into contact with and
leave a cutting mark on the end faces of the three
soft jaws.
The diameter of the cutting mark must be smaller
than the finishing diameter.
30)
Display the POSITION (INCREMENTAL) screen.
NOTE
NOTE
NOTE
NOR
SPJ
STOP
REV
NOTE
Cutting mark
NOTE
