B-32 MANUAL OPERATION
19.
The selected rotary tool is mounted in the Z-axis direction (only for MC type)
(only in the spindle and rotary tool spindle simultaneous operation mode).
20.
The C-axis is not connected. (MC type)
21.
The protection cover of the tool presetter arm is mounted to the base.
22.
The bar feeder or bar puller is not in the emergency stop state
(only for bar feeder, bar puller specification).
7-2
Starting and Stopping Spindle Rotation
The procedures for starting and stopping spindle rotation in manual operation are described here.
<Starting spindle rotation>
1)
Place the DOOR INTERLOCK key-switch in the
NORMAL
position.
2)
Check the chucking pressure with a pressure gage.
If it is incorrect, adjust the pressure.
3)
Clamp a workpiece in the chuck.
4)
Make sure that the STATUS indicator
[CHCL]
is lit.
If it is not lit, check the workpiece chucking status
and the setting for the chucking direction.
5)
Place the PANEL key-switch in one of the positions
indicated below.
(ON)
(PANEL/EDIT)
6)
Press the HEAD CHANGE switch
(head 1) or
(head 2) to select the spindle to be rotated. (S
type)
DOOR INTERLOCK
NORMAL
RELEASE
X
Z
M00/M01
M02/M30
STATUS
ERR
CHCL
MRDY
TRCL
NOTE
ON
PANEL
/EDIT
OFF
PANEL
2
1
HEAD CHANGE
1
2
