Mitsubishi Electric F920GOT-BBD-K-E, Hardware Manual

Page: 548 / 592

GOT-F900 SERIES (CONNECTION) Connection of Printer 21
21-2
21.2 System Configuration
The printer can be connected to the RS-232C port of the GOT-F900. This section explains the cable
required to connect the printer.
21.2.1 Configuration for Printer Connection
Connect the GOT-F900 to the printer.
21.2.2 Applicable port on GOT-F900
The printer can be connected to a RS-232C port on the GOT-F900 if it is not occupied with the setting
for other equipment such as a PLC, bar code reader or printer.
F940WGOT is equipped with the two RS-232C ports. Either port is applicable for connecting a printer.
21.3 Printer Communication Setting
When connecting the printer, the transmission specifications and the communication format described
below should be satisfied in the printer.
21.3.1 Transmission Specifications and Communication Format
Set the transmission specifications and the communication format of the printer as shown in the table
below.
1) Applicable printer
The printer which can be connected via ESC/P (Epson Standard Code for Printer) control code and
the RS-232C interface is applicable.
2) Transmission specifications
- For the setting of "DON ' T USE/USE" of the printer, refer to section 21.5.
a) Printer b) RS-232C cable
RS-232C port on printer side
25-pin D-Sub, male Prepared by the user
9-pin D-Sub, male Prepared by the user
Setting item
Communication setting
(default value in [ ])
Remarks
(Write set value of printer.)
GOT-F900 GT Designer DU/WIN
SPEED Speed Speed [300],600,1200,2400,4800,9600
DATA BIT Data Bit Databits [7 bits],8 bits
STOP BIT Stop Bit Stopbits [1 bit],2 bits
PARITY Parity Parity [Even], Odd, None
HANDSHAKING Handshaking Handshake [DTR/DSR], XON/XOFF
PRINTER
− −
[DON'T USE], USE
Select "DON'T USE" except
special cases.
a) Printer
F940GOT
F943GOT
F930GOT
GOT-F900
b) RS-232C cable
Equipped with
RS-232C I/F