Mitsubishi Electric F920GOT-BBD-K-E, Hardware Manual, Page: 446 / 592

GOT-F900 SERIES (CONNECTION) Connection of FLEX-PC N Series PLC (Manufactured by Fuji Electric) 16
16-4
16.3 Setting in Link Unit
When connecting the link unit, the switches in the link unit should be set as described below.
16.3.1 Communication Setting Specifications
This section explains the setting in the link unit.
1) Setting the mode setting switch (link connection)
Set the mode so that the COM port of the link unit connected to the GOT-F900 is the asynchronous
system and no protocol. (In the NJ-CPU-B16, the setting below is not required.)
2) Setting the transmission specifications
Set the transmission specifications in the link unit as shown in the table below.
For the switch setting method, refer to the manual of the link unit.
- The specifications such as the transmission speed are fixed on the GOT-F900 side, and cannot be changed.
3) Setting the station number setting switches (link connection)
(In the NJ-CPU-B16, the station number cannot be set.)
The setting range varies depending on the OS version as shown in the table below.
COM port Set value Remarks
RS-422 3 Command setting type: asynchronous system, no protocol
RS-232C 1 Command setting type: asynchronous system, no protocol
Item
Link unit connection CPU direct connection
RS-422 RS-232C RS-232C
Transmission speed 19200 bps
Data
format
Data bit 7 bits (JIS) 8 bits (HEX)
Parity bit Even Odd
Stop bit 1 bit
GOT-F900 OS version Setting
F920GOT-K
− −
F930GOT 3.00 or later
Set the value set in the GOT-F900 (0 to 31).
F930GOT-K 4.60 or later
F940GOT 5.00 or later
F940WGOT 1.00 or later
F940 Handy GOT 5.00 or later
F943 Handy GOT 5.00 or later
Any version earlier than above Set the value set in the GOT-F900 (0 to 15).