Mitsubishi Electric F920GOT-BBD-K-E, Hardware Manual, Page: 120 / 592

GOT-F900 SERIES (CONNECTION) Installation and Wiring of Handy GOT 5
5-18
5.4.3 Installation of External Cable
This section explains the procedure to install an optional external cable to the Handy GOT.
1) Remove rear cover
Rear face of Handy GOT
Remove four mounting screws "a)", and open the rear cover.
Installation screw M3(0.12")
×
8
Note:
Never remove any screw (among seven screws located around the
rear face of the Handy GOT) other than the mounting screws "a)".
If such a screw is removed, the waterproof ability may deteriorate
or failure may occur.
When rear cover is open
2) Connect an external cable
a) Insert an external cable into the installation hole C) of the main unit, and connect it to the ports A)
and B).
a)
Note
D )
C )
A ) B )
A)Power supply
connector (8 pins)
B) Connector for
communication and
operation switches
(20 pins)
C)Installation hole
D)Packing
Handy GOT
Handy GOT RH model
A)Power supply
connector
(CN1: 8 pins)
B) Connector for
communication and
operation switches
(CN2: 20 pins)
C)Connector for grip
switch (CN4: 5 pins)
D)Connector for
emergency stop
(CN5: 4 pins)
E) Installation hole
(CN6: 3 pins)
F) Installation hole
G)Packing
G )
F )
A )
B )
C ) E )
D )
W h e n p u s h i n g t h e
c a b l e t h r o u g h , m a k e
e a c h c o n n e c t o r f a c e
d o w n w a r d .