Micro Motion CDM100M, Configuration And Use Manual

Page: 146 / 220

c. Click
Fix mA
.
d. Read the mA current at the receiving device and compare it to the transmitter
output.
The readings do not need to match exactly. If the values are slightly different,
you can correct the discrepancy by trimming the output.
e. Click
UnFix mA
.
f. Enter 20 in Fix to: .
g. Click Fix mA .
h. Read the mA current at the receiving device and compare it to the transmitter
output.
The readings do not need to match exactly. If the values are slightly different,
you can correct the discrepancy by trimming the output.
i. Click UnFix mA .
2. Test the discrete output(s).
a. Choose Device Tools > Diagnostics > Testing > Discrete Output Test .
b. Set
Fix To:
to
ON
.
c. Verify the signal at the receiving device.
d. Set
Fix To: to OFF .
e. Verify the signal at the receiving device.
f. Click
UnFix
.
3. Test the TPS output.
a. Attach a frequency counter, oscilloscope, digital multimeter (DMM), or digital
voltmeter (DVM) to the TPS output loop.
b. Compare the reading to the Sensor Time Period process variable at your meter.
Postrequisites
• If the mA output readings are within 200 microamps of each other, you can correct
this discrepancy by trimming the output.
• If the discrepancy between the mA output readings is greater than 200 microamps,
or if at any step the reading was faulty, verify the wiring between the transmitter
and the remote device, and try again.
• If the discrete output readings are reversed, check the setting of Discrete Output
Polarity .
• If the TPS output readings do not match, contact Micro Motion customer service.
Troubleshooting
140 Micro Motion ® Compact Density Meters (CDM)