Juniper QFX3000-G QFabric, Deployment Manual, Page: 623 / 652

show fabric administration inventory interconnect-devices
Supported Platforms QFabric System
Syntax show fabric administration inventory interconnect-devices interconnect-device-name
Release Information Command introduced in Junos OS Release 11.3 for the QFX Series.
Description (QFabric systems only) Display the Interconnect devices that belong to a QFabric system.
Options none —Display all Interconnect devices within a QFabric system.
interconnect-device-name
—Display a specific Interconnect device within a QFabric system.
Required Privilege
Level
admin
Related
Documentation
request chassis fabric fpc on page 483
•
•
show chassis fabric connectivity on page 560
•
show chassis fabric device on page 567
•
show fabric administration inventory on page 584
•
Understanding Interconnect Devices on page 21
List of Sample Output show fabric administration inventory interconnect-devices on page 598
show fabric administration inventory interconnect-devices device-name on page 598
Output Fields Table 102 on page 597 lists the output fields for the
show fabric administration inventory
interconnect-devices
command. Output fields are listed in the approximate order in which
they appear.
Table 102: show fabric administration inventory interconnect-devices Output Fields
Field Description Field Name
Name of the Interconnect devices associated with the partition. Interconnect device
Type of QFabric system component being viewed.
Interconnect devices either display the alias name (if configured) or the hardware serial identifier and
Control Board Routing Engine numbers.
Item
Hardware serial identifier of a QFabric system component. When you configure an alias name for a
component, the ID is displayed. Identifier
Status of a QFabric system component: either
Connected
or
Disconnected
, depending on whether or
not the Director software has detected keepalive messages for the listed component.
Connection
Whether or not the configuration for a QFabric system component has been received and installed.
The configuration can be
Configured , Failed (unsuccessful), Pending (in the process of being written
or retried), or
Unknown
.
Configuration
597 Copyright © 2015, Juniper Networks, Inc.
Chapter 21: Operational Mode Commands