Juniper QFX3000-G QFabric, Deployment Manual, Page: 216 / 652

9.
Replace the cover on the wiring compartment, and using a number 1 Phillips (+)
screwdriver, tighten the four screws.
10.
Repeat Step 3 through Step 9 for the other wiring tray.
Related
Documentation
Powering On a QFX3008-I Interconnect Device on page 191
•
•
Wiring Tray in a QFX3008-I Interconnect Device
•
Wiring Tray LEDs on a QFX3008-I Interconnect Device
Connecting a QFX Series Device to a Management Console
Supported Platforms QFabric System , QFX3500, QFX3600
The QFX Series has a console port with an RJ-45 connector. Use the console port to
connect the device to a management console or to a console server.
Ensure that you have an RJ-45 to DB-9 rollover cable available. An RJ-45 cable with an
RJ-45 to DB-9 adapter is provided with the device.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to the QFX Series, use a
combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with the
device and a USB to DB-9 male adapter. You must provide the USB to DB-9
male adapter.
To connect the QFX Series to a management console (see Figure 21 on page 151 and
Figure 22 on page 151 ):
1.
Connect one end of the Ethernet cable to the console port (labeled
CON
or
CONSOLE
).
2.
Connect the other end of the Ethernet cable into the console server (see
Figure 21 on page 151 ) or management console (see Figure 22 on page 151 ).
Figure 37: Connecting the QFX Series to a Management Console Through
a Console Server
Copyright © 2015, Juniper Networks, Inc. 190
QFX3000-G QFabric System Deployment Guide