Juniper QFX3000-G QFabric, Deployment Manual, Page: 222 / 652

•
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Prevention of Electrostatic Discharge Damage .
• Verify that the site meets the requirements described in Site Preparation Checklist for
a QFX3600 or QFX3600-I Device .
•
Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
• Read General Safety Guidelines and Warnings , with particular attention to Chassis Lifting
Guidelines for a QFX3600 or QFX3600-I Device .
•
Remove the device from the shipping carton (see “Unpacking a QFX3600 or QFX3600-I
Device” on page 194 ).
Ensure that you have the following parts and tools available:
• ESD grounding strap (provided)
• One pair of mounting brackets depending on how you want to mount the device
(provided)
•
Use the front/rear mounting brackets (part number 540-038579) to front-mount
or rear-mount the device.
• Use the mid-mounting brackets (part number 540-038665) to mid-mount the
device.
•
6 Phillips 4x6-mm pan-head mounting screws (provided)
•
Four screws to secure the chassis to the rack (not provided)
• Appropriate screwdriver for the mounting screws (not provided)
NOTE: One person must be available to lift the device while another secures
the device to the rack.
CAUTION: If you are mounting multiple device on a rack, mount a device in
the bottom of the rack first and proceed to mount the rest of the devices
from bottom to top.
To mount the device on two posts in a rack:
1.
Attach the ESD grounding strap to your bare wrist and to a site ESD point.
2.
Place the device on a flat, stable surface.
3.
Align the mounting brackets along the front or rear of the side panels of the device
chassis depending on how you want to mount the device. For example, if you want
to front-mount the device, align the brackets along the front of the side panel.
Copyright © 2015, Juniper Networks, Inc. 196
QFX3000-G QFabric System Deployment Guide