Juniper QFX3000-G QFabric, Deployment Manual, Page: 285 / 652

To connect each QFX3600-I Interconnect device to the fiber-based control plane network:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
NOTE: Before you connect each cable to a device, if the fiber-optic cable
connector is covered by a rubber safety cap, remove the cap. If the transceiver
is covered with a rubber safety cap, remove the cap. Save the caps for future
use.
1.
Connect the first QFX3008-I Interconnect device.
a.
Connect one end of the first fiber optic cable to the SFP optical transceiver in the
first management port labeled (labeled
0
) on the first Control Board (labeled
CB
0
).
b.
Connect the other end of that cable to port ge-0/0/19 on the first Virtual Chassis.
c.
Connect one end of the second fiber optic cable to the SFP optical transceiver in
the second management port (labeled
1 ) on CB0 .
d.
Connect the other end of that cable to port
ge-0/0/19
on the second Virtual Chassis.
e.
Connect one end of the third fiber optic cable to the SFP optical transceiver in the
first management port labeled (labeled
0 ) on the second Control Board (labeled
CB 1 ).
f.
Connect the other end of that cable to port
ge-1/0/19
on the first Virtual Chassis.
g.
Connect one end of the fourth fiber optic cable to the SFP optical transceiver in
the second management port (labeled
1
) on
CB1
.
h.
Connect the other end of that cable to port ge-1/0/19 on the second Virtual Chassis.
2.
Connect the second QFX3008-I Interconnect device.
a.
Connect one end of the first fiber optic cable to the SFP optical transceiver in the
first management port labeled (labeled
0
) on the first Control Board (labeled
CB
0
).
b.
Connect the other end of that cable to port ge-2/0/19 on the first Virtual Chassis.
c.
Connect one end of the second fiber optic cable to the SFP optical transceiver in
the second management port (labeled
1 ) on CB0 .
d.
Connect the other end of that cable to port
ge-2/0/19
on the second Virtual Chassis.
e.
Connect one end of the third fiber optic cable to the SFP optical transceiver in the
first management port labeled (labeled
0 ) on the second Control Board (labeled
259 Copyright © 2015, Juniper Networks, Inc.
Chapter 14: Cabling a Fiber-Based Control Plane for the QFX3000-G QFabric System