Juniper QFX3000-G QFabric, Deployment Manual, Page: 504 / 652

•
show fabric administration system mac-pool
• show fabric inventory
• show fabric session-host
•
show log
•
show system software upgrade status
QFabric System Operational Mode Commands
Supported Platforms QFabric System
Table 91 on page 478 summarizes the command line interface (CLI) commands that you
can use to monitor and troubleshoot the QFabric system operations.
Table 91: QFabric System Operational Mode Commands
Command Task
request chassis device-mode
Select the operating mode for the device.
request chassis fabric fpc
Set the Interconnect device Flexible PIC Concentrator
(FPC) offline or online for the QFabric system.
request component login
Log in to individual QFabric system components for
device level troubleshooting.
request fabric administration
director-group change-master
Select a Director device to become the new primary
device within a Director group.
request fabric administration remove
Remove a disconnected component from the QFabric
system inventory.
request fabric administration system
mac-pool add
Add a MAC range to the MAC pool assigned to the QFabric
system.
request fabric administration system
mac-pool delete Delete a MAC range from the MAC block assigned to the
QFabric system.
request system halt director-device
Halt a Director device.
request system reboot Reboot QFabric system components.
request system software
nonstop-upgrade
Upgrade the software version of the QFabric system by
using the nonstop software upgrade method (which
preserves forwarding functionality during the upgrade
and enables components to upgrade on a rotating basis).
request system software
system-backup
Save the software package and system configuration
files to be able to recover the QFabric system in the case
of a system failure.
set chassis display message Specify information to be displayed on the LCD panel of
a QFabric system device.
Copyright © 2015, Juniper Networks, Inc. 478
QFX3000-G QFabric System Deployment Guide