Juniper QFX3000-G QFabric, Deployment Manual, Page: 173 / 652

4.
Mount the attached mounting bracket to the rack post. Tighten all screws.
5.
Attach the mounting bracket on the opposite end of the same side to the QFX3100
Director device and mount it to the rack post. Tighten all screws.
6.
Repeat this procedure for the mounting brackets on the opposite side of the QFX3100
Director device. Tighten all screws.
7.
Ensure that the QFX3100 Director device chassis is level by verifying that all screws
on one side of the rack are aligned with the screws on the other side. See
Figure 18 on page 147 .
Figure 18: Mounting the QFX3100 Director Device on Two Posts in a Rack
Attach the front bracket to the chassis, and secure
the chassis to the post. Attach the rear bracket to the
other side of the post, and secure the chassis to
the rear bracket, adjusting the bracket width as needed.
g050062
Related
Documentation
Rack-Mounting and Cabinet-Mounting Warnings
•
•
Installing and Connecting a QFX3100 Director Device on page 143
•
Connecting AC Power to a QFX3100 Director Device on page 149
Mounting a QFX3100 Director Device on Four Posts in a Rack or Cabinet
Supported Platforms
QFabric System
You can mount a QFX3100 Director device on four posts of a 19-in. rack or cabinet by
using the adjustable rear mounting brackets provided. (The remainder of this topic uses
“rack” to mean “rack or cabinet.”)
Before mounting the QFX3100 Director device on four posts in a rack:
•
Verify that the site meets the requirements described in Site Preparation Checklist for
a QFX3100 Director Device .
• Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
•
Read General Safety Guidelines and Warnings .
•
Remove the QFX3100 Director device from the shipping carton (see “Unpacking a
QFX3100 Director Device” on page 144 ).
147 Copyright © 2015, Juniper Networks, Inc.
Chapter 9: Installing a QFX3100 Director Device