Juniper QFX3000-G QFabric, Deployment Manual, Page: 202 / 652

5.
In a four-post rack, place the grounding lug attached to the grounding cable over one
of the rear support anchors, as shown in
Figure 28 on page 176 .
In a two-post rack, place the grounding cable lug over the grounding points on the
bottom rear of the chassis below the wiring trays.
The left pair is sized for M6 screws, and the right pair is sized for UNC ¼-20 screws.
6.
Using the torque screwdriver, secure the grounding lug to the protective earthing
terminal.
Figure 28: Connecting a Grounding Cable to a QFX3008-I Interconnect
Device
g050168
Related
Documentation
Site Preparation Checklist for a QFX3008-I Interconnect Device
•
Connecting AC Power to a QFX3008-I Interconnect Device with Single-Phase Wiring
Trays
Supported Platforms
QFX3000-G
A QFX3008-I Interconnect device is configured with six AC power supplies and two wiring
trays.
CAUTION: Mixing different types of wiring trays in the same chassis is not a
supported configuration.
CAUTION: To meet safety and electromagnetic interference (EMI)
requirements and to ensure proper operation, the QFX3008-I Interconnect
device must be adequately grounded before it is connected to power.
Copyright © 2015, Juniper Networks, Inc. 176
QFX3000-G QFabric System Deployment Guide