Juniper QFX3000-G QFabric, Deployment Manual, Page: 287 / 652

Connect the other end of that cable to port
ge-3/0/18
on the second Virtual Chassis.
h.
Related
Documentation
Connecting a QFX3600 Node Device to a QFX3008-I Interconnect Device on page 269
•
•
Connecting a QFX3500 Node Device to a QFX3008-I Interconnect Device on page 271
Connecting a QFX3600 Node Device to a Fiber-Based QFX3000-G QFabric System
Control Plane Network
Supported Platforms QFX3000-G
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX Series devices in your network to two Virtual Chassis composed of
EX4200 switches. If you are creating a fiber-based control plane network, you use eight
EX4200-24F Ethernet switches in each Virtual Chassis. QFX3600 Node devices have
RJ-45 and SFP management ports. Use the SFP management ports (labeled
C0S and
C1S ) to connect the QFX3500 Node device to each Virtual Chassis (see
Figure 75 on page 261 ).
Figure 75: QFX3600 Node Device Fiber-Based Control Plane Connections
for QFX3000-M QFabric System
VC0
VC1
ge-0/0/0
ge-0/0/0
C1S
C0S
Use the following QFX3600 Node devices and EX4200 switches for a fiber-based
QFX3000-G QFabric system control plane network:
• QFX3600 Node devices.
•
EX4200-24F switches with an SFP+ uplink module installed.
261 Copyright © 2015, Juniper Networks, Inc.
Chapter 14: Cabling a Fiber-Based Control Plane for the QFX3000-G QFabric System