Juniper QFX3000-G QFabric, Deployment Manual, Page: 309 / 652

•
Software Installation Overview
•
Connecting a QFX3500 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 241
•
Connecting a QFX3600 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 238
•
Connecting a QFX3500 Node Device to a QFX3008-I Interconnect Device on page 271
•
Connecting a QFX3600 Node Device to a QFX3008-I Interconnect Device on page 269
•
Connecting a QFX3500 Node Device to a Copper-Based QFX3000-M QFabric System
Control Plane Network
•
Connecting a QFX3500 Node Device to a Fiber-Based QFX3000-M QFabric System
Control Plane Network
•
Connecting a QFX3600 Node Device to a Copper-Based QFX3000-M QFabric System
Control Plane Network
•
Connecting a QFX3600 Node Device to a Fiber-Based QFX3000-M QFabric System
Control Plane Network
•
Connecting a QFX3500 Node Device to a QFX3600-I Interconnect Device
•
Connecting a QFX3600 Node Device to a QFX3600-I Interconnect Device
Example: Configuring the Virtual Chassis for the QFX3000-G QFabric System Control
Plane
Supported Platforms QFabric System
This example shows you how to connect QFabric system components and configure the
Virtual Chassis used by the QFX3000-G QFabric system control plane network. Proper
wiring of Director devices, Interconnect devices, and Node devices to the Virtual Chassis,
combined with a standard configuration, enables you to bring up the internal QFabric
system management network and prepare your QFabric system for full operation.
• Requirements on page 283
• Overview on page 284
•
Configuration on page 295
•
Verification on page 311
Requirements
This example uses the following hardware and software components:
•
One QFX3000-G QFabric system containing:
• Two QFX3100 Director devices
• Two QFX3008-I Interconnect devices
283 Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Initial Setup