Juniper QFX3000-G QFabric, Deployment Manual, Page: 223 / 652

NOTE:
• If you use the front or rear mounting brackets (part number
540-038579), align the brackets such that the mounting ears are at the
location where you want to mount the device. For example, if you want
to front-mount the device, align the brackets such that the mounting
ears are in the front of the device chassis. See
Figure 39 on page 197 .
•
If you use the mid-mounting brackets (part number 540-038665), align
the brackets such that the mounting ears are in the center of the side
panels. See
Figure 40 on page 197 .
4.
Align the holes in the mounting brackets with holes on the side panels of the device
chassis.
5.
Insert mounting screws into the aligned holes. Tighten the screws.
6.
Have one person grasp both sides of the device, lift the device, and position it in the
rack, aligning the mounting ear holes with the threaded holes in the rack or cabinet
rail. Align the bottom mounting ear hole in both the mounting brackets with a hole in
each rack rail, making sure the chassis is level. See
Figure 40 on page 197 .
7.
Have a second person secure the device to the rack by using the appropriate screws.
Tighten the screws.
8.
Ensure that the device chassis is level by verifying that all screws on one side of the
rack are aligned with the screws on the other side.
Figure 39: Attaching the Front or Rear Mounting Brackets to the Side
Panel of the Device
g050215
Figure 40: Mounting the Device on Two Posts in a Rack
AC
!
DC
g050216
AC
!
DC
197 Copyright © 2015, Juniper Networks, Inc.
Chapter 11: Installing a QFX3600 Node Device