Juniper QFX3000-G QFabric, Deployment Manual, Page: 317 / 652

Table 78: Director Group Port Mappings (continued)
Virtual Chassis VC1 Virtual Chassis VC0
Director
Device
•
Module 1, port 0 to ge-0/0/41 on VC1
• Module 1, port 1 to ge-1/0/41 on VC1
•
Module 1, port 2 to ge-2/0/41 on VC1
• Module 1, port 3 to module 1, port 3 on DG0
•
Module 0, port 0 to ge-0/0/41 on VC0
• Module 0, port 1 to ge-1/0/41 on VC0
•
Module 0, port 2 to ge-2/0/41 on VC0
• Module 0, port 3 to module 0, port 3 on DG0
DG1
In the software, the ports of each network module are reversed, numbered from right to
left, and incremented sequentially across modules. If you issue interface operational
commands directly on the Director device, please note the following port mappings as
shown in
Table 79 on page 291 :
Table 79: Hardware to Software Port Mappings for Director Device Network Modules
Port 3 Port 2 Port 1 Port 0 Network Module
eth2 eth3 eth4 eth5 Module 0
eth6 eth7 eth8 eth9 Module 1
Figure 79 on page 292 shows the specific ports on the Interconnect devices that you must
connect to the Virtual Chassis. In general, connect one port from each Control Board
module in an Interconnect device to the first Virtual Chassis, and a second port from each
Control Board module to the second Virtual Chassis.
291 Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Initial Setup