Juniper QFX3000-G QFabric, Deployment Manual, Page: 280 / 652

on the second network module (also labeled
0
through
2
) to the second Virtual Chassis
(
VC1
). The ports used are the same on each Virtual Chassis.
Table 71: QFX3100 Director Device-to-VIrtual Chassis Control Plane Port Assignments for DG0
Network Module Port 3
Network Module Port
2 Network Module Port
1 Network Module Port
0
Connect this port to the identical port on the
other Director device. See
“Connecting
QFX3100 Director Devices in a Director
Group” on page 228
.
Virtual Chassis port
ge-2/0/22
Virtual Chassis port
ge-1/0/22
Virtual Chassis port
ge-0/0/22
2.
Connect both network modules on the second Director device (labeled DG1 in
Figure 73 on page 252 ) to the two Virtual Chassis (labeled VC0 and VC1 in
Figure 73 on page 252 ). You connect the first three ports on the first network module
to the first Virtual Chassis (
VC0
). You connect the first three ports on the second
network module to the second Virtual Chassis (
VC1
). The ports used are the same on
each Virtual Chassis.
Table 72: Second QFX3100 Director Device-to-Virtual Chassis Control Plane Port Assignments
for DG1
Network Module Port 3
Network Module Port
2 Network Module Port
1 Network Module Port
0
Connect this port to the identical port on the
other Director device. See
“Connecting
QFX3100 Director Devices in a Director
Group” on page 228
.
Virtual Chassis port
ge-2/0/23
Virtual Chassis port
ge-1/0/23
Virtual Chassis port
ge-0/0/23
Related
Documentation
Installing and Connecting a QFX3100 Director Device on page 143
•
Connecting a QFX3100 Director Device to a Network for Out-of-Band Management
Supported Platforms QFabric System
Use the management port on your QFX3100 Director device to connect each Director
device in your Director group to your out-of-band management network.
NOTE: You cannot use the management port to perform the initial
configuration of the QFX3100 Director device. You must configure the
management port before you can successfully connect to the QFX3100
Director device using this port. See
“Performing the QFabric System Initial
Setup on a QFX3100 Director Group” on page 362 .
Ensure that you have an RJ-45 patch cable available.
Copyright © 2015, Juniper Networks, Inc. 254
QFX3000-G QFabric System Deployment Guide