Juniper QFX3000-G QFabric, Deployment Manual, Page: 290 / 652

8.
Repeat this procedure for each QFX3600 Node device.
9.
Secure the cables so that they are not supporting their own weight. Place excess cable
out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain
their shape.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. An arc smaller than a few inches in diameter can damage the cables
and cause problems that are difficult to diagnose.
Do not let fiber-optic cables hang free from the connector. Do not allow
fastened loops of cables to dangle, which stresses the cables at the
fastening point.
Related
Documentation
Connecting a QFX3600-I Interconnect Device to a Fiber-Based QFX3000-M QFabric
System Control Plane Network
•
•
Connecting a QFX3600 Node Device to a QFX3600-I Interconnect Device
•
Connecting QFX3100 Director Devices to a Fiber-Based QFX3000-M QFabric System
Control Plane Network
•
Connecting QFX3100 Director Devices in a Director Group on page 228
Connecting a QFX3500 Node Device to a Fiber-Based QFX3000-G QFabric System
Control Plane Network
Supported Platforms
QFX3000-G
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX Series devices in your network to two Virtual Chassis composed of
EX4200 switches. If you are creating a fiber-based control plane network, you use eight
EX4200-24F Ethernet switches in each Virtual Chassis. QFX3500 Node devices have an
RJ-45 or SFP management board. Use the SFP management ports (labeled
C0
and
C1
)
to connect the QFX3500 Node device to each Virtual Chassis (see Figure 76 on page 265 ).
Copyright © 2015, Juniper Networks, Inc. 264
QFX3000-G QFabric System Deployment Guide