Juniper QFX3000-G QFabric, Deployment Manual, Page: 353 / 652

lo0 up up
lo0.0 up up inet 10.255.195.97 --> 0/0
iso
47.0005.80ff.f800.0000.0108.0001.0102.5519.5097
inet6 abcd::10:255:195:97
fe80::2ac0:da0f:fc31:1e81
lsi up up
me0 up up
me0.0 up up inet 10.94.195.97/24
mtun up up
pimd up up
pime up up
tap up up
vlan up up
vme up up inet 192.168.157.27/24
Meaning In the output of the
show virtual-chassis status
command, if all four members appear,
the Virtual Chassis is operational.
In the output of the
show interfaces terse
command, if all interfaces that connect to the
QFabric system devices are listed as up (such as ge-0/0/39, ge-1/0/39, ge-2/0/39, and
ge-3/0/39 for the Interconnect devices; ge-0/0/40, ge-1/0/40, and ge-2/0/40 for the
Director devices; ge-0/0/0 through ge-0/0/7 for the Node devices; and xe-0/1/0, xe-0/1/2,
xe-1/1/0, xe-1/1/2, xe-2/1/0, xe-2/1/2, xe-3/1/0, and xe-3/1/2 for the inter-Virtual Chassis
connections), the control plane is properly connected.
Related
Documentation
QFX3000-G QFabric System Installation Overview on page 83
•
•
Installing and Connecting a QFX3100 Director Device on page 143
•
Installing and Connecting a QFX3008-I Interconnect Device on page 155
•
Installing and Connecting a QFX3500 Device on page 211
•
Installing and Connecting an EX4200 Switch
•
Configuring an EX4200, EX4500, or EX4550 Virtual Chassis (CLI Procedure)
•
Understanding the QFabric System Control Plane on page 35
Example: Configuring a Fiber-Based Control Plane for the QFX3000-G QFabric System
Supported Platforms QFabric System
This example shows you how to connect components and configure switches used by
a fiber-based QFX3000-G QFabric system control plane network. Proper wiring of Director
devices, Interconnect devices, and Node devices to the control plane switches, combined
with a standard configuration, enables you to bring up the internal QFabric system
management network and prepare your QFabric system for full operation.
•
Requirements on page 328
• Overview on page 328
• Configuration on page 339
•
Verification on page 353
327 Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Initial Setup