Juniper QFX3000-G QFabric, Deployment Manual, Page: 271 / 652

CHAPTER 14
Cabling a Fiber-Based Control Plane for
the QFX3000-G QFabric System
• Interconnecting Two Virtual Chassis for Fiber-Based QFX3000-G QFabric System
Control Plane Redundancy on page 245
•
Connecting QFX3100 Director Devices in a Director Group on page 248
•
Connecting QFX3100 Director Devices to a Fiber-Based QFX3000-G QFabric System
Control Plane Network on page 251
• Connecting a QFX3100 Director Device to a Network for Out-of-Band
Management on page 254
•
Connecting a QFX3008-I Interconnect Device to a Fiber-Based QFX3000-G QFabric
System Control Plane Network on page 255
• Connecting a QFX3600 Node Device to a Fiber-Based QFX3000-G QFabric System
Control Plane Network on page 261
•
Connecting a QFX3500 Node Device to a Fiber-Based QFX3000-G QFabric System
Control Plane Network on page 264
Interconnecting Two Virtual Chassis for Fiber-Based QFX3000-G QFabric System
Control Plane Redundancy
Supported Platforms
QFX3000-G
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX Series devices in your network to two Virtual Chassis. If you are
creating a fiber-based control plane network, you use eight EX4200-24F Ethernet switches
in each Virtual Chassis. For redundancy and communication, you must connect the two
Virtual Chassis using the 10-Gigabit Ethernet uplink module ports configured as a link
aggregation group (LAG) (see
Figure 68 on page 246 ).
245 Copyright © 2015, Juniper Networks, Inc.