Juniper QFX3000-G QFabric, Deployment Manual, Page: 213 / 652

9.
Replace the cover on the wiring compartment, and using a number 1 Phillips (+)
screwdriver, tighten the four screws.
10.
Repeat Step 3 through Step 9 for the other wiring tray.
Related
Documentation
Powering On a QFX3008-I Interconnect Device on page 191
•
•
Wiring Tray in a QFX3008-I Interconnect Device
•
Wiring Tray LEDs on a QFX3008-I Interconnect Device
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Wye
Wiring Trays
Supported Platforms
QFX3000-G
A QFX3008-I Interconnect device is configured with six AC power supplies and two wiring
trays.
CAUTION: Mixing different types of wiring trays in the same chassis is not a
supported configuration.
CAUTION: To meet safety and electromagnetic interference (EMI)
requirements and to ensure proper operation, the QFX3008-I Interconnect
device must be adequately grounded before it is connected to power.
For installations that require a separate grounding conductor to the chassis,
use the protective earthing terminal on the QFX3008-I Interconnect device
to connect to earth ground. For instructions on connecting a QFX3008-I
Interconnect device to ground using a separate grounding conductor, see
“Connecting Earth Ground to a QFX3008-I Interconnect Device” on page 174 .
A QFX3008-I Interconnect device receives additional grounding when you
plug the power supply in the device into a grounded AC power outlet by using
the AC power cord appropriate for your geographical location. See
“AC Power
Cord Specifications for a QFX3008-I Interconnect Device with Three-Phase
Wye Wiring Trays” on page 136
.
NOTE: Each wiring tray must be connected to a dedicated AC power source
outlet.
Before you begin to connect power to the device:
• Ensure that you understand how to prevent ESD damage. See Prevention of Electrostatic
Discharge Damage .
187 Copyright © 2015, Juniper Networks, Inc.
Chapter 10: Installing a QFX3008-I Interconnect Device