Juniper QFX3000-G QFabric, Deployment Manual, Page: 251 / 652

CHAPTER 13
Cabling a Copper-Based Control Plane for
the QFX3000-G QFabric System
• Interconnecting Two Virtual Chassis for Copper-Based QFX3000-G QFabric System
Control Plane Redundancy on page 225
•
Connecting QFX3100 Director Devices in a Director Group on page 228
•
Connecting QFX3100 Director Devices to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 231
• Connecting a QFX3100 Director Device to a Network for Out-of-Band
Management on page 233
•
Connecting a QFX3008-I Interconnect Device to a Copper-Based QFX3000-G QFabric
System Control Plane Network on page 234
• Connecting a QFX3600 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 238
•
Connecting a QFX3500 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 241
Interconnecting Two Virtual Chassis for Copper-Based QFX3000-G QFabric System
Control Plane Redundancy
Supported Platforms
QFX3000-G
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX Series devices in your network to two Virtual Chassis. If you are
creating a copper-based control plane network, you use four EX4200-48T Ethernet
switches in each Virtual Chassis. For redundancy and communication, you must connect
the two Virtual Chassis using the 10-Gigabit Ethernet uplink module ports configured as
a link aggregation group (LAG) (see
Figure 59 on page 226 ).
225 Copyright © 2015, Juniper Networks, Inc.