Juniper QFX3000-G QFabric, Deployment Manual, Page: 263 / 652

To connect each QFX3008-I Interconnect Device to the QFX3000-G QFabric system
control plane network (see
Figure 65 on page 235 :
1.
Connect the first Interconnect device.
a.
Connect one end of the first RJ-45 patch cable to the first SFP management port
(labeled
0
) on the first Control Board (labeled
CB 0
).
b.
Connect the other end of that cable to port ge-0/0/39 on the first Virtual Chassis.
c.
Connect one end of the second RJ-45 patch cable to the second SFP management
port (labeled
1 ) on the first Control Board (labeled CB 0 ).
d.
Connect the other end of that cable to port
ge-0/0/39
on the second Virtual Chassis.
e.
Connect one end of the third RJ-45 patch cable to the first SFP management port
(labeled
0 ) on the second Control Board (labeled CB 1 ).
f.
Connect the other end of that cable to port
ge-1/0/39
on the first Virtual Chassis.
g.
Connect one end of the fourth RJ-45 patch cable to the second SFP management
port (labeled
1
) on the second Control Board (labeled
CB 1
).
h.
Connect the other end of that cable to port ge-1/0/39 on the second Virtual Chassis.
2.
Connect the second Interconnect device.
a.
Connect one end of the first RJ-45 patch cable to the first SFP management port
(labeled
0
) on the first Control Board (labeled
CB 0
).
b.
Connect the other end of that cable to port ge-2/0/39 on the first Virtual Chassis.
c.
Connect one end of the second RJ-45 patch cable to the second SFP management
port (labeled
1
) on the first Control Board (labeled
CB 0
).
d.
Connect the other end of that cable to port
ge-2/0/39
on the second Virtual Chassis.
e.
Connect one end of the third RJ-45 patch cable to the first SFP management port
(labeled
0 ) on the second Control Board (labeled CB 1 ).
f.
Connect the other end of that cable to port
ge-3/0/39
on the first Virtual Chassis.
g.
Connect one end of the fourth RJ-45 patch cable to the second SFP management
port (labeled
1
) on the second Control Board (labeled
CB 1
).
h.
Connect the other end of that cable to port ge-3/0/39 on the second Virtual Chassis.
3.
(Optional) Connect the third Interconnect device.
a.
Connect one end of the first RJ-45 patch cable to the first SFP management port
(labeled
0
) on the first Control Board (labeled
CB 0
).
b.
Connect the other end of that cable to port ge-0/0/38 on the first Virtual Chassis.
c.
Connect one end of the second RJ-45 patch cable to the second SFP management
237 Copyright © 2015, Juniper Networks, Inc.
Chapter 13: Cabling a Copper-Based Control Plane for the QFX3000-G QFabric System