Juniper QFX3000-G QFabric, Deployment Manual, Page: 182 / 652

Before you begin, ensure that the installation site meets the requirements described in
Site Preparation Checklist for a QFX3008-I Interconnect Device .
To install and connect a QFX3008-I Interconnect device:
1.
Follow the instructions in “Unpacking a QFX3008-I Interconnect Device” on page 156 .
2.
Install the mounting hardware on your four-post or two-post rack or cabinet by
following the instructions in
“Installing QFX3008-I Interconnect Device Mounting
Hardware on Four-Post Racks or Cabinets” on page 159 or “Installing QFX3008-I
Interconnect Device Mounting Hardware on Two-Post Racks” on page 167 .
3.
Mount the device by following the instructions in “Mounting a QFX3008-I Interconnect
Device on a Rack or Cabinet Using a Mechanical Lift” on page 170 .
4.
Connect the QFX3008-I Interconnect device to earth ground.
See “Connecting Earth Ground to a QFX3008-I Interconnect Device” on page 174 .
5.
Connect power to the device.
See “Connecting AC Power to a QFX3008-I Interconnect Device with Single-Phase
Wiring Trays” on page 176 , “Connecting AC Power to a QFX3008-I Interconnect Device
with Three-Phase Delta Wiring Trays” on page 183 , and “Connecting AC Power to a
QFX3008-I Interconnect Device with Three-Phase Wye Wiring Trays” on page 187 .
6.
(Optional) Install the cable management system or lockable front doors, by following
the instructions in
Installing the Cable Management System on a QFX3008-I Interconnect
Device and Installing the Lockable Front Doors on a QFX3008-I Interconnect Device .
7.
See “QFX3000-G QFabric System Installation Overview” on page 83 for information
about the next steps to install and configure your QFX3000 QFabric system.
Related
Documentation
Rack Requirements for a QFX3008-I Interconnect Device
•
•
Cabinet Requirements for a QFX3008-I Interconnect Device
•
Clearance Requirements for Airflow and Hardware Maintenance for a QFX3008-I
Interconnect Device
•
Chassis Lifting Guidelines for a QFX3008-I Interconnect Device
Unpacking a QFX3008-I Interconnect Device
Supported Platforms
QFX3000-G
After you prepare the installation site as described in Site Preparation Checklist for a
QFX3008-I Interconnect Device , you may unpack the device.
NOTE: The device is maximally protected inside the shipping box. Do not
unpack it until you are ready to begin installation.
Copyright © 2015, Juniper Networks, Inc. 156
QFX3000-G QFabric System Deployment Guide