Juniper QFX3000-G QFabric, Deployment Manual, Page: 385 / 652

vlan up up
vme up up
vme0.0 up up inet 192.168.157.27/24
Meaning In the output of the
show virtual-chassis status
command, if all eight members appear,
the Virtual Chassis is operational.
In the output of the
show interfaces terse
command, if all interfaces that connect to the
QFabric system devices are listed as up (such as ge-0/0/0 through ge-0/0/7 for the
Node devices; ge-0/0/19, ge-1/0/19, ge-2/0/19, and ge-3/0/19 for the Interconnect
devices; ge-0/0/22, ge-0/0/23, ge-1/0/22, ge-1/0/23, ge-2/0/22, and ge-2/0/23 for the
Director devices; and xe-0/1/0, xe-1/1/0, xe-2/1/0, xe-3/1/0, xe-4/1/0, xe-5/1/0, xe-6/1/0,
and xe-7/1/0 for the inter-Virtual Chassis connections), the control plane is properly
connected.
NOTE: The ae0 and ae1 LAG connections on Virtual Chassis VC1 appear as
down
in the output of the
show interfaces terse
command because they are
the backup connections to the Director devices. The active, primary LAG
connections are typically on Virtual Chassis VC0.
Related
Documentation
QFX3000-G QFabric System Installation Overview on page 83
•
•
Installing and Connecting a QFX3100 Director Device on page 143
•
Installing and Connecting a QFX3008-I Interconnect Device on page 155
•
Installing and Connecting a QFX3500 Device on page 211
•
Installing and Connecting a QFX3600 or QFX3600-I Device on page 193
•
Installing and Connecting an EX4200 Switch
•
Configuring an EX4200, EX4500, or EX4550 Virtual Chassis (CLI Procedure)
•
Understanding the QFabric System Control Plane on page 35
Importing a QFX3000-G QFabric System Control Plane Virtual Chassis Configuration
with a USB Flash Drive
Supported Platforms QFabric System
359 Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Initial Setup