Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 75 / 256

4.
Enable transmission of MDL messages.
host1(config-controll)# mdl transmit path-id
host1(config-controll)# mdl transmit idle-signal
host1(config-controll)# mdl transmit test-signal
mdl carrier
•
Use to specify that an interface is used in the carrier environment.
•
Example
host1(config-controll)# mdl carrier
•
Use the no version to restore the default situation, in which the interface does not
operate in the carrier environment.
•
See mdl carrier.
mdl string
•
Use to specify an MDL message.
•
Example
host1(config-controll)# mdl string port 0800
•
Use the no version to restore the default value to the specified MDL message or to all
MDL messages.
•
See mdl string.
mdl transmit
•
Use to enable transmission of MDL messages.
•
Specify the keyword path-id to transmit path identifications every second.
•
Specify the keyword idle-signal to send idle signals every second.
•
Specify the keyword test-signal to transmit test signals every second.
•
Example
host1(config-controll)# mdl transmit test-signal
•
Use the no version to disable transmission of the specified MDL message or all MDL
messages.
•
See mdl transmit.
Optional Tasks
The following configuration tasks are optional for T3 and E3 interfaces:
• Specify the cable length (T3 only).
• Change the clock source.
•
Change the framing format.
53 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Configuring T3 and E3 Interfaces