Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 87 / 256

•
For definitions of the MIB statistics, see RFC 2496—Definitions of Managed Objects
for the DS3/E3 Interface Types (January 1999)
•
Field descriptions
•
Description—Text description or alias if configured for the interface
•
ifAdminStatus—One of the following administrative states of the interface:
•
ifAdminUp—Interface is administratively enabled
•
ifAdminDown—Interface is administratively disabled
•
ifAdminTesting—Interface is administratively configured in a testing state
•
snmp trap link-status—Status of SNMP trapping (enabled or disabled)
•
alarms detected—One of the following T3 alarms (not applicable for E3):
•
No alarm present—No alarms present on the line
•
Rcv RAI Failure—Remote device is sending a far end alarm failure
•
Xmt RAI Failure—Local device is sending a far end alarm failure
•
Rcv AIS—Remote device is sending an alarm indication signal (AIS)
•
Xmt AIS—Local device is sending an AIS
•
Rcv LOF—Loss of one or more frames from the remote end
•
Rcv LOS—Loss of signal at the local end
NOTE: The alarms detected field does not appear for interfaces that you disabled in
the software.
•
framing—Type of framing format
•
line code—Type of line code format
•
clock source—Type of clock source
•
cable length—Cable length, in feet (this field is not present for E3 controllers)
•
Loopback—State of loopback for the controller: enabled or disabled. If loopback is
enabled, one of the following states is displayed:
•
Diagnostic—Data loops back toward the router and sends an alarm AIS toward
the network
•
Payload—Data loops toward the network after the framer has processed the data
•
Line—Data loops toward the network before the data reaches the framer
•
loopback state—State of loopback for the controller: enabled or disabled
65 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Configuring T3 and E3 Interfaces