Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 219 / 256

•
down—Hardware is not operational
•
Administrative status—Operational state that you configured for this interface
•
up—Interface is enabled
•
down—Interface is disabled
•
Hardware—Type of MAC device on this interface
•
Address—MAC address of the processor on this interface
•
MAU—Type of medium attachment unit (MAU) on the physical port:
•
10BASE-T (10 Mbps)
•
100BASE-TX (100 Mbps)
•
100BASE-FX-MM (100 Mbps) with the distance appearing after the type
•
100BASE-LX-SM (100 Mbps)
•
SFP (Empty)—SFPs that are empty
•
SFP (Non-compliant Juniper Part)—SFPs that are installed in the FE-8 I/O module
and do not have a Juniper Networks part number programmed
•
MTU—Size of the MTU for this interface
•
Operational—Size of the largest packet processed
•
Administrative—Setting for MTU size that you specified
•
Duplex Mode—Duplex option for this interface
•
Operational—Duplex option currently used
•
Administrative—Setting for duplex that you specified
•
Speed—Line speed for this interface
•
Operational—Current rate at which packets are processed
•
Administrative—Setting for line speed
•
5 minute input rate—Data rates based on traffic received in the last 5 minutes
•
5 minute output rate—Data rates based on traffic sent in the last 5 minutes
•
De-bounce—Debounce configuration for this interface
•
State is—Enabled, Disabled
•
Interval is—Number of seconds that this interface maintains a given state before
the state change is reported to the upper-layer links
•
In—Analysis of inbound traffic on this interface
197 Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Configuring Ethernet Interfaces