Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 71 / 256

T3 (DS3) ports per I/O module. Each port uses two SMB connectors: one for the transmit
(TX) connection and one for the receive (RX) connection.
CT3/T3-F0 line modules and CT3/T3 12 I/O I/O modules to support the following:
•
Clocking
•
Redundancy
• Frame Relay logical interface support
• Unique IP interface support for each PPP or Frame Relay PVC interface
•
Line speeds of 45 Mbps
Interface Stack
Figure 3 on page 49 shows the stack for T3 ATM interfaces. Figure 4 on page 49 shows
the stack for T3 frame and E3 frame interfaces.
To configure a T3 ATM interface, first configure a T3 controller. To configure ATM
parameters, see
Configuring ATM in JunosE Link Layer Configuration Guide .
To configure a T3 frame or E3 frame interface, first configure a T3 or E3 controller, and
then configure a High-Speed Data Link Control (HDLC) data channel on the controller.
Figure 3: Stack for T3 ATM Interfaces
Figure 4: Stack for T3 Frame and E3 Frame Interfaces
NOTE: For a detailed description of interface types and specifiers, see Interface Types
and Specifiers in JunosE Command Reference Guide. For information about interfaces,
see Planning Your Network in JunosE System Basics Configuration Guide.
Numbering Scheme
This section describes how to identify T3 and E3 interfaces.
A T3/E3 controller on an ATM or frame interface is identified using the slot/port format,
where:
• slot —Number of the slot in which the line module resides in the chassis. In ERX7xx
models, line module slots are numbered 2-6 (slots 0 and 1 are reserved for SRP
modules). In ERX14xx models, line module slots are numbered 0–5 and 8–13 (slots 6
and 7 are reserved for SRP modules). In the ERX310 router, the line module slots are
numbered 0–2 (slot 0 is reserved for the SRP module).
49 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Configuring T3 and E3 Interfaces