Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 146 / 256

3.
(Optional) Configure the interface to operate in an FDL carrier environment.
host1(config-controll)# path 2 ds1 1/1/1 fdl carrier
4.
(Optional) Specify the FDL messages.
host1(config-controll)# path 2 ds1 1/1/1 fdl string eic "ERX1410"
host1(config-controll)# path 2 ds1 1/1/1 fdl string lic "Bldg 10"
host1(config-controll)# path 2 ds1 1/1/1 fdl string fic "GY788"
host1(config-controll)# path 2 ds1 1/1/1 fdl string unit 080001
5.
Enable transmission of FDL messages.
host1(config-controll)# path 2 ds1 1/1/1 fdl transmit idle-signal
path ds1 fdl
•
Use to specify the FDL standard for the interface.
•
Specify the keyword ansi to support the ANSI FDL standard (see “References” on
page 113).
•
Specify the keyword att to support the AT&T FDL standard (see “References” on
page 113).
•
Specify the keyword all to support both the ANSI and AT&T standards.
•
Specify the keyword none to remove the current FDL mode settings.
•
You can configure a different standard on each T1 channel.
•
Example
host1(config-controll)# path 2 ds1 1/1/1 fdl att
•
Use the no version to restore the default, none.
•
See path ds1 fdl.
path ds1 fdl carrier
•
Use to specify that an interface is used in the carrier environment.
•
Example
host1(config-controll)# path 2 ds1 1/1/1 fdl carrier
•
Use the no version to restore the default situation, in which the T1 interface does not
operate in the carrier environment.
•
See path ds1 fdl carrier.
path ds1 fdl string
Copyright © 2010, Juniper Networks, Inc. 124
JunosE 11.2.x Physical Layer Configuration Guide