Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 155 / 256

•
You can configure a different standard on each T1 channel.
•
Example
host1(config-controll)# path 2 ds3 1 t1 20-28 fdl att
•
Use the no version to restore the default, no specified FDL standard.
•
See path ds3 t1 fdl.
path ds3 t1 fdl carrier
•
Use to specify that T1 channels are used in the carrier environment.
•
Example
host1(config-controll)# path 2 ds3 1 t1 4,6,10-14 fdl carrier
•
Use the no version to restore the default situation, in which the T1 channel does not
operate in the carrier environment.
•
See path ds3 t1 fdl carrier.
path ds3 t1 fdl string
•
Use to configure an FDL message as defined in the ANSI T1.403 specification.
NOTE: The router sends these FDL messages only if you have issued the path ds3 t1 fdl
command with the ansi or all keyword and then issued the path ds3 t1 fdl transmit
command.
•
Example
host1(config-controll)# path 2 ds3 1 t1 28 fdl string eic "ERX1440",
•
Use the no version to restore the default value to the specified FDL message or to all
FDL messages.
•
See path ds3 t1 fdl string.
path ds3 t1 fdl transmit
•
Use to configure the router to send the specified type of FDL message.
•
By default, the router sends only FDL performance data messages.
NOTE: The router sends FDL messages specified with the path ds3 t1 fdl string command
only if you have issued the path ds3 t1 fdl command with the ansi or all keyword. If you
specified the att keyword with the path ds3 t1 fdl command, the router sends only
performance data.
•
Specify the keyword path-id to transmit path identifications every second.
•
Specify the keyword idle-signal to send idle signals every second.
133 Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Configuring Channelized OCx/STMx Interfaces