Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 108 / 256

•
Use to specify that the interface supports SDH.
•
Example
host1(config-controller)# sdh
•
Use the no version to revert to SONET operation on this interface.
•
See sdh.
shutdown
•
Use to disable a SONET/SDH interface.
•
SONET/SDH interfaces are enabled by default.
•
Example
host1 (config-controll)# shutdown
•
Use the no version to restart a disabled interface.
•
See shutdown.
snmp trap link-status
•
Use to enable SNMP link-status processing for the section and line layers of the
interface.
•
The default is enabled.
•
Example
host1(config-controll)# no snmp trap link-status
•
Use the no version to disable SNMP link status processing.
•
See snmp trap link-status.
trigger delay
•
Use to set the time that the router waits to set an alarm when the router records a
defect at the line or section layer.
•
Change this value from the default only when you are using MPLS fast reroute over a
SONET/SDH interface.
•
Specify a value of 0 milliseconds if the interface does not use APS/MSP or if you
want MPLS to have priority over APS/MSP.
•
Specify a value of at least 100 milliseconds if this interface uses APS/MSP and if
you want APS/MSP to have priority over MPLS.
•
Example
host1(config-controll)# trigger delay msec 1000
•
Use the no version to restore the default setting, 2500 milliseconds.
•
See trigger delay.
Copyright © 2010, Juniper Networks, Inc. 86
JunosE 11.2.x Physical Layer Configuration Guide