Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 74 / 256

•
port —Number of the port on the I/O module
•
Example
host1(config)# controller e3 3/2
•
There is no no version.
•
See controller e3.
controller t3
Use to specify a T3 controller in slot/port format.
•
•
slot —Number of the slot in which the line module resides in the chassis
•
port —Number of the port on the I/O module
•
Example
host1(config)# controller t3 0/1
•
There is no no version.
•
See controller t3.
shutdown
•
Use to disable a T3 or an E3 controller.
•
The T3 or E3 interface is disabled by default.
•
Example
host1(config-controll)# shutdown
•
Use the no version to restart a disabled interface.
•
See shutdown.
Configuring MDL Messages
You can configure a T3 interface to send MDL messages. MDL messages are supported
only when T3 framing uses C-bit parity, the default setting.
To configure a T3 interface to send MDL messages:
1.
Specify a T3 interface.
host1(config)# controller t3 8/0
2.
(Optional) Configure the interface to operate in an MDL carrier environment.
host1(config-controll)# mdl carrier
3.
Specify the MDL messages.
host1(config-controll)# mdl string eic "ERX1410"
host1(config-controll)# mdl string fic "FG786"
host1(config-controll)# mdl string lic “ Bldg 10"
host1(config-controll)# mdl string pfi "Site 25"
host1(config-controll)# mdl string port 0800
Copyright © 2010, Juniper Networks, Inc. 52
JunosE 11.2.x Physical Layer Configuration Guide