Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 215 / 256

•
Example 2—Selects the Fast Ethernet management port on an E320 router
host1(config)# interface fastEthernet 6/0/0
•
Use the no version to remove IP from an interface or subinterface. You must issue the
no version from the highest level down; you cannot remove an interface or subinterface
if the one above it still exists.
•
See interface fastEthernet.
interface gigabitEthernet
•
Use to select a Gigabit Ethernet interface.
NOTE: On the GE I/O module, you can configure only the primary port, 0. The router
automatically uses the redundant port, 0R, if the primary port fails.
On the GE-2 SFP I/O module, you can configure only the primary ports, 0 and 1. The
router automatically uses the corresponding redundant port, 0R or 1R, if the primary
port fails.
On the OC3-2 GE APS I/O module, you can configure only port 2. Ports 0 and 1 are
reserved for OC3/STM1 ATM interfaces. This I/O module does not support redundant
ports in the current release.
On the ES2-S1 GE-4 IOA, you can configure all four ports.
On the ES2-S1 GE-8 IOA, you can configure all eight ports.
•
Use the slot/port [ .subinterface ] format for Gigabit Ethernet interfaces on ERX7xx
models, ERX14xx models, or the ERX310 router; use the slot/adapter/port format for
Gigabit Ethernet interfaces on the E120 and E320 routers.
•
Example 1—Selects a Gigabit Ethernet interface on ERX7xx models, ERX14xx models,
and the ERX310 router
host1(config)# interface gigabitEthernet 1/0
host1(config)# interface gigabitEthernet 2/1
•
Example 2—Selects a Gigabit Ethernet interface on the E320 router
host1(config)# interface gigabitEthernet 4/0/1
•
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
•
See interface gigabitEthernet.
interface tenGigabitEthernet
193 Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Configuring Ethernet Interfaces