•
Use to set thresholds for the bit error rates associated with APS/MSP alarms.
•
This command does not apply to the working interface. You can issue this command
only for the protect interface.
•
Specify one of the following keywords to indicate the alarm level:
•
sd-ber
—Bit error rate that specifies signal degradation
•
sf-ber
—Bit error rate that specifies signal failure
•
Specify an integer
n
in one of the following ranges, where
n
corresponds to a rate of
10-n (10e-
n
) errors per second.
•
For
sd-ber
, an integer in the range 5–9; the default value is 5
•
For
sf-ber
, an integer in the range 3–5; the default value is 3
•
Example
host1(config-controll)#
threshold sf-ber 4
•
Use the
no
version to restore the default, 5 (for
sd-ber
) or 3 (for
sf-ber
), for the specified
alarm.
•
See threshold.
Configuring the Protect Interface
To configure the protect interface:
1.
Select the interface.
host1(config)#
controller sonet 4/1
2.
Specify the APS group to which the protect and working interfaces will belong.
host1(config-controll)#
aps group boston
3.
Specify the protect interface.
host1(config-controll)#
aps protect
4.
(Optional) Prevent the protect interface from taking over automatically if the working
interface fails.
host1(config-controll)#
aps lockout
5.
(Optional) Enable the router to revert to the working interface when it recovers.
host1(config-controll)#
aps revert 7
6.
(Optional) Specify that switchover takes place in unidirectional mode.
host1(config-controller)#
aps unidirectional
aps group
•
Use to specify the group to which the working and protect interfaces will belong.
•
Specify the name of the APS group.
•
Example
Copyright © 2010, Juniper Networks, Inc.
88
JunosE 11.2.x Physical Layer Configuration Guide
Summary of Contents for JUNOSE 11.2.X MULTICAST ROUTING
