Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 43 / 256

•
Use to enable data stream inversion for the interface.
•
Enable data stream inversion only if it is turned on at the other end of the line.
•
Example
host1(config-if)# invert data
•
Use the no version to disable data inversion.
•
See invert data.
load-interval
•
Use to set the time interval at which the router calculates bit and packet rate counters.
•
You can choose a multiple of 30 seconds, in the range 30–300 seconds.
•
Example
host1(config-if)# load-interval 90
•
Use the no version to restore the default value, 300 seconds.
•
See load-interval.
mru
•
Use to configure the MRU size for the interface.
•
Specify a value in the range 4–9996 bytes.
•
You should coordinate this value with the network administrator on the other end of
the line.
•
If you configure a different MRU value in higher-level protocols, such as IP, the router
uses the lower value. This can produce unexpected behavior in your network.
•
Example
host1(config-if)# mru 1600
•
Use the no version to restore the default, 1600 bytes.
•
See mru.
mtu
•
Use to configure the MTU size for the interface.
•
Specify a value in the range 4–9996 bytes.
•
You should coordinate this value with the network administrator on the other end of
the line.
•
If you configure a different MTU value in higher-level protocols, such as IP, the router
uses the lower value. This can produce unexpected behavior in your network.
•
Example
host1(config-if)# mtu 1600
21 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring Channelized T3 Interfaces