Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 36 / 256

Configuring T1 Channels
To configure T1 channels and subchannels:
1.
From Global Configuration mode, specify the T3 controller in slot 0, port 1.
host1(config)# controller t3 0/1
2.
Assign a range of timeslots to a channel and subchannel.
For example, assign the following range of timeslots: 1, 3–8, and 10 to channel 2,
subchannel 1. Timeslots 2, 9, and 11–24 are available for other subchannels.
host1(config-controll)# t1 2/1 timeslots 1,3-8,10
Optional Tasks
The T1 channel configuration commands enable you to specify options for a single channel,
multiple individual channels, ranges of channels, or any combination of the three types
of specifications. For example:
host1(config-controll)# t1 2,4,6-15,20-25 clock source line
The following configuration tasks are optional when you configure T1 channels:
• Disable T1 channels.
• Change the clock source.
•
Assign a text description or an alias to the interface.
•
Change the framing format.
• Enable or disable SNMP link status processing.
• Configure FDL messages.
controller t3
Use to specify a T3 controller in slot/port format.
•
•
slot —Number of the slot in which the line module resides in the chassis
•
port —Number of the port on the I/O module
•
Example
host1(config)# controller t3 0/1
•
There is no no version.
•
See controller t3.
t1 clock source
•
Use to configure the transmit clock source for T1 channels.
•
The router supports internal and line clocking .
Copyright © 2010, Juniper Networks, Inc. 14
JunosE 11.2.x Physical Layer Configuration Guide